AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Osb cement plaster12/15/2023 Momentum FN 50 in the application environment temperature +5 ✬ -35✬. NOTE: If there is a wait, the material should be used after mixing well. Prepared mixtures are applied to the surface with a trowel or machine. The prepared mixture should be used within 2 hours. It is recommended that we mix all the bags at the same time before the mixtures are prepared. One bag of Momentum FN 50 (or half of it by adding sufficient amount of water) is poured into the container where the mixture will be made and 14,0-15,5 liters of water is added and mixed with the mixer for 6-8 minutes. NOTE: if the application area is very large on the concrete and gross concrete surfaces, the use of the net is eliminated. If the surface to be applied is gross concrete adherence enhancer must be applied to the surface (MOMENTUM CORSE PRIMER-0,250 /m2 2 coats) and then a cement-based adhesive is applied in the form of a thin layer and heat insulation plaster should be applied. If the surface to be applied is old and black plaster If the floor is swollen by checking, or if there is an under plaster space, after removing these, adherence enhancing concrete primer should be applied (MOMENTUM CORSE PRIMER-0,250 / m2 2 layers) Adhesion enhancer, Gross concrete primer should be applied to the surface after cleaning and repair (MOMENTUM CORSE PRIMER-0,250 / m2 2 layer) If the application surface is old and painted surface notched and swollen all parts should be removed from the ground. If the application surfaces are damaged, they must be removed before plastering. The surfaces to be applied must be dry and clean. Concrete, reinforced concrete, brick, pumice, aerated concrete, gypsum board, betopan, OSB, restoration of old buildings and works, interior and exterior insulation of buildings.
0 Comments
Read More
Leave a Reply. |